Uponor SmatrixMove User Manual

4 Install Uponor Smatrix Move/Move PLUS
4.1 Installation procedure
Uponor Smatrix Move
Uponor recommends following the process described
below to guarantee the best possible installation results.
Stage Procedure Page
1 Prepare for installation 12
2 Install Uponor Smatrix Move/Move PLUS
controller
19
3 Finishing installation 37
Uponor Smatrix Move PLUS
Uponor recommends following the process described
below to guarantee the best possible installation results.
Stage Procedure Page
1 Prepare for installation 12
2 Install Uponor Smatrix Move/Move PLUS
controller
19
3 Install Uponor Smatrix Wave/Wave PLUS
thermostats and sensors
27
4 Finishing installation 37
4.2 Prepare for installation
Before starting the installation:
• Verify the contents of the package with the packing
list.
See also section 3.3 Uponor Smatrix Move/Move
PLUS components for identification of components.
• Check whether an external temperature sensor is
to be installed with a compatible thermostat (Move
PLUS only).
• Study the wiring diagram in the end of this manual.
To determine where to best place the Uponor Smatrix
Move/Move PLUS components, follow these guidelines:
• Ensure that the controller can be installed close to
the mixing valve actuator or pump.
• Ensure that the controller can be mounted close
to a 230 V AC wall socket, or if required by local
regulations to a junction box, connected to the
mains power.
• Ensure that installed components are protected
from running or dripping water.
• We recommend that the Uponor Smatrix Move
PLUS antenna is mounted in vertical position.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
12
UPONOR SMATRIX MOVE/MOVE PLUS · INSTALLATION AND OPERATION MANUAL

Uponor SmatrixMove Specifications

General

Brand	Uponor
Model	SmatrixMove
Category	Temperature Controller
Language	English