To Next Page

To Previous Page

You can add CM18045 handsets to the CM18445 console at

any time, each new handset must be registered with the console

before use.

The handsets are assigned with available

extension numbers starting from 1 in ascending

order (1 to 9). You can register a maximum of

nine devices to the console.

To register the handset to the CM18445

console:

Start registration when the handset shows

1) Press MENU on Console ->Registration

->Register Ext. 2) Press # on this

extension to register.

1. On the console, press MENU/SELECT.

2. Press or to scroll to Registration,

then press MENU/SELECT or /SKIP.

3. Press MENU/SELECT or /SKIP to

choose Register ext. The console shows

Registering....

4. On the handset, press #. The handset

shows Registering....

5. You hear a beep sound when the

registration process is successful. The

handset shows Handset X registered. (X

represents the extension number, ranged from

1 to 9). It takes up to 60 seconds to complete

the registration process.

6. Press a line key (LINE 1 - LINE 4). If you hear

a dial tone, the registration was successful.

NOTE: If the registration is not successful, the console returns to the previous

screen. To reset the handset, remove the handset from the charger. Wait for

about two minutes, then try the registration process again.

Getting started

Add and register a handset

VTech CM18045 User Manual

Other manuals for VTech CM18045