EasyManuals Logo
Home>WEISS>Control Systems>HP140T Series

WEISS HP140T Series User Manual

WEISS HP140T Series
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
WEISS
Installation- and operating manual Handling device HP140T R09-2011
35/52
Commissioning
6.1 Safety during commissioning
6
6 Commissioning
6.1 Safety during commissioning
Ensure that the machine is only commissioned by qualified personnel in compliance
with the safety instructions.
Ensure that only authorised personnel are in the work area, and that no one could be
injured due to the commissioning process.
The following prerequisites must be met prior to commissioning the machine:
The machine is correctly mounted.
The electrical equipment for the power supply is available and correctly fitted.
All cables are laid properly and correctly connected in compliance with valid electrical
circuit documents.
The shielding of the motor wires is in place.
The static discharge must be conducted properly.
The shunt resistance must be measured and have a value of < 10 MOhm.
The measurement must be recorded in a log.
The required safety equipment and emergency stop circuits are available and
functioning correctly.
Prior to commissioning the machine, check whether
the drive is undamaged and not blocked.
all connections have been correctly established.
all safety covers are correctly installed.
no other hazard sources are present.
no foreign materials, tools or other objects are lying in the operating area of the
machine.
The following should be checked during commissioning
the axles are running properly.
Jerking of the axles may indicate incorrect control parameters.
no excessive noise development is detected.
A strong development of noise may indicate improper assembly or incorrect con-
trol parameters.
Injuries emanating from unexpected activation.
Incorrectly-established connections or external influences on electrical equipment can
cause unexpected activation of the machine or uncontrolled movement. Ensure that
nobody is present in the hazardous zone around the machine. Activate and check all
safety equipment and emergency stop circuits prior to commissioning.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WEISS HP140T Series and is the answer not in the manual?

WEISS HP140T Series Specifications

General IconGeneral
BrandWEISS
ModelHP140T Series
CategoryControl Systems
LanguageEnglish

Related product manuals