WEISS
Installation- and operating manual Handling device HP140T R09-2011
43/52
Decommissioning / Dismantling / Disposal
10.1 Safety during decommissioning and dismantling
10
10 Decommissioning / Dismantling / Disposal
10.1 Safety during decommissioning and dismantling
10.2 Decommissioning
10.2.1 Temporary decommissioning
The machine should be deactivated for decommissioning and secured against uninten-
tional reactivation.
The machine should be fitted with a sign that clearly indicates that it is temporarily
decommissioned.
For recommissioning, comply with the instructions in chapter 6.3.
10.3 Dismantling and disposal
Injuries can occur during disassembly through falling components.
The following points must be observed to avoid injuries and/or environmental damage
during dismantling and disposal:
• In order to avoid injury, ensure that suitable tools are used and that dismantled
machine components are stable.
• Note that emerging lubricant, solvent, preserving agents, etc. can cause cauterizing
and burns if they come into direct contact with skin.
Strong magnetic fields
Strong magnetic fields are emitted from the permanent magnets. The magnetic pull
increases very strongly at close range (< 150 mm). Magnetisable materials but also hand-
ling devices mutually, are attracted with a great force. Disassembly only by qualified,
trained and instructed personnel. A second person must always be present during disas-
sembly. Transport disassembled machines individually. Do not stack disassembled
machines. Do not bring any magnetisable objects near the machine. Keep separating
tools at hand for emergencies. Danger of severe crushing or pinching.
Injury of unauthorised persons.
Ensure that decommissioning and dismantling is only realised by persons trained,
instructed and authorised for this purpose. These persons should be familiar with the
operating manual and act in accordance with it.
To Next Page
Loading...
Need help?
General
