Installation- and operating manual Handling device HP140T R09-2011
42/52
Maintenance
9.5 Repair
9
9.4.1.1 Grease
a) First lubricating by the factory and re-lubricating with LE special grease Synth EP2
with qualities as follows:
• Standard for cleanness by FDA guideline 21 CFR 178.3570
• Clearance by NSF H1 (National Sanitary Foundation)
Alternative the use of a comparable grease is possible.
b) Use of grease without FDA-Certifikation
• DIN 51502: KP2K-30
• ISO 6743-9: ISO-L-X-CCEB 2
In this case the original grease has to be pressed out of the bea-
rings completely. Do not mix greases.
9.4.1.2 Amount of grease
• 1.0 cm
3
for the vertical axle
• 0.6 cm
3
for the horizontal axle
9.5 Repair
The operator should not perform any maintenance or repair work on the machine.
Should maintenance or repair work become necessary, the customer service of WEISS
GmbH is to be contacted.
Type of thickener Al-Complex
Operating temperatur for long-term lubrication -45 °C bis +160 °C
Short time admissible temperature peak value +200 °C
Drop point (ASTM D 2265) > 250 °C
Worked penetration (ASTM D 217) 265 - 295
Type od base oil synthetic
Base oil viscosity at 40 °C (ASTM D 445) 350 mm
2
/s
Water resistance (DIN 51807 T1) 0 - 90
SKF Emcor Test (DIN 51802) Corrosion degree 0/0
Designation (DIN 51502) KPFHC 2 P-40
To Next Page
Loading...
Need help?
General
