Xerox DocuPrint 2065 User Manual

6.6 Error Messages and Error Codes 149
6.6 Error Messages and Error Codes
Error Messages (in Alphabetical Order)
The following table lists the error messages that appear on the control panel.
Note
• When a message cannot be displayed in one screen, the display switches between two or three screens
to display the entire message. The   in the following table indicates the screen switching motion of the
display.
Message Symptom/Cause/Remedy
Clear Jam from
Bypass Tray or
 
Open A
Clear Jam
A paper jam occurred in the printer.
Remove the jammed paper from the bypass tray. Then, open the front cover. If you
see the jammed paper, remove it from the printer.
Refer to
• "6.1 Clearing Paper Jams" (P. 133)
Close A & C The front cover or top cover is open.
Close the cover.
Refer to
• "2.1 Main Components and Functions" (P. 34)
Close D The inner cover is open.
Close the inner cover.
Refer to
"2.1 Main Components and Functions" (P. 34)
Disk is full
 
Press SET
and Cancel JOB
The hard disk (optional) is full.
Cancel the print job by pressing the <Eject/Set> button on the control panel.
Increase the hard disk space by deleting the files that are unnecessary.
Install
Toner Cartridge
A print cartridge is not installed.
Install a print cartridge appropriate for the printer.
Refer to
• "Replacing the Print Cartridge" (P. 160)
• "Type of Consumable" (P. 158)
Invalid job
 
Press SET
and Cancel JOB
The job was not printed since the request is not valid.
This message may appear when the accessory configuration settings differ from the
actual configuration (for example, you requested 2-sided printing when the duplex
unit is not installed, but it is set to [Available] on the print driver).
Cancel the job by pressing the <Eject/Set> button on the control panel.
Correctly specify the print request and try printing again.
Invalid feature
 
Press SET
and Cancel JOB
If the Authentication feature is used, you are not registered as a user who is
authorized to print. Cancel the job by pressing the <Eject/Set> button on the control
panel.
For information about the user registration, consult your system administrator.
Limit reached
 
Press SET
and Cancel JOB
The number of pages permitted to print that is set on the [Print Auditron] on
CentreWare Internet Services has reached the maximum.
Cancel the job by pressing the <Eject/Set> button on the control panel.
For information about the Print Auditron, consult your system administrator.
Load in Bypass
xx xx xxxx
The size of the paper loaded in the bypass tray does not match the paper size
specified by the job.
Load the paper indicated in the message (xx xx xxxx) in the bypass tray.
Refer to
• "Loading Paper in the Bypass Tray" (P. 83)

Xerox DocuPrint 2065 Specifications

General

Brand	Xerox
Model	DocuPrint 2065
Category	Printer
Language	English