40 2 Basic Operation
2.3 About the Circuit Breaker
The printer has a circuit breaker on its rear left side.
In the event of current leakage, the breaker will automatically cut off the power circuit to
prevent any current leakages or fire from occurring.
If the circuit breaker trips, check insulation condition of the printer and then press the
<RESET> button.
If the insulation condition of the printer is not recovered, the circuit breaker trips again
immediately. In such case, contact our Customer Support Center or your dealers.
Once a month, switch the printer off and test if the breaker is functioning normally. Using a
failed breaker puts your printer at risk of electric shock.
If your circuit breaker is not functioning normally, contact our Customer Support Center or
your dealers.
Refer to
• For information on how to test the circuit breaker, refer to " Operational Safety" (P. 13).
RESET button
To Next Page
Loading...
Need help?
General