Troubleshooting 196
The Output Is Too Light
NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji
Xerox local representative office or an authorised dealer.
Problem Action
The output is too light. The toner cartridges may be low or need to be replaced. Confirm the
amount of toner in each toner cartridge.
1 Check the toner level in the Status tab in the Printer Status
window.
2 Replace the toner cartridges as necessary.
Verify that the print media is dry and the correct print media is used.
If not, use the print media recommended for the printer.
See also:
• "Usable Print Media" on page 69
Try changing the Paper Type setting in the print driver.
1 On the Paper/Output tab in Printing Preferences of the print
driver, change the Paper Type setting.
Disable Toner Saving Mode in the print driver.
1 On the Graphics tab in Printing Preferences of the print driver,
ensure that the Toner Saving Mode check box is not selected.
To Next Page
Loading...
Need help?
General