Selecting Fax Options
Phaser® 8510/8560MFP Multifunction Product
6-16
Selecting the Starting Rate
Select the highest starting rate unless the fax destination for the fax you are sending has special
requirements.
To select the transmission speed for a fax:
1. On the control panel, press the Fax button.
2. Select
Starting Rate, and then press the OK button.
3. Select an option from the list displayed, and then press the OK button.
Note: The factory default is 33.6 kbps (Super G3) for Phaser 8560MFP products and
14.4 kbps for Phaser 8510MFP products.
Delay Sending a Fax
To send a fax at a specified time (within 24 hours):
1. On the control panel, press the Delayed Send button.
2. Select
Send later, and then press the OK button.
3. Select the time to send the fax:
■ Hour to send: Select a number from 0 to 23, and the press the OK button.
■ Minute to send: Select a number from 0 to 59, and then press the OK button.
4. Select one of the following options on the
Time to send screen:
■ Select OK to accept the delayed send time.
■ Select Change to change the delayed send time. Follow the prompts to revise the
delayed send time.
5. If desired, select other control panel options, and then press the Start button. The fax is
scanned and saved to be sent at the time you specified.
To Next Page
Loading...
Need help?
General
