Xerox Phaser 8560MFP User Manual

Configuring the Network Address
Phaser® 8510/8560MFP Multifunction Product
2-9
Manually Setting the System’s IP Address
Note: Verify that your computer has a properly configured IP address for your network.
Contact your network administrator for more information.
If you are on a network without a DNS server, or in an environment where the network
administrator assigns system IP addresses, you can use this method to manually set the IP
address. Manually setting the IP address overrides DHCP and AutoIP. Alternatively, if you are
in a small office with a single PC and use a dialup modem connection, you can manually set
the IP address.
1. On the control panel, press the System button.
2. Select
Connection Setup, and then press the OK button.
3. Select
Network Setup, and then press the OK button.
4. Select
TCP/IP Setup, and then press the OK button.
5. Select
DHCP/BOOTP, select Off, and then press the OK button.
6. Select
TCP/IP Address, and then press the OK button.
7. Enter the system’s IP address, and then press the OK button.
See also:
Advanced Features Guide at www.xerox.com/office/8510_8560support

Xerox Phaser 8560MFP Specifications

General

Brand	Xerox
Model	Phaser 8560MFP
Category	All in One Printer
Language	English