Phaser® 8510/8560MFP Multifunction Product
A-2
If you notice unusual noises or odors:
1. Turn off the system immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative to correct the problem.
The power cord is attached to the system as a plug-in device on the side of the system. If it is
necessary to disconnect all electrical power from the system, disconnect the power cord from
the electrical outlet.
Warning: Do not remove the covers or guards that are fastened with screws unless you are
installing optional equipment and are specifically instructed to do so. Power should be OFF
when performing these installations. Disconnect the power cord when removing covers and
guards for installing optional equipment. Except for user-installable options, there are no parts
that you can maintain or service behind these covers.
Note: Leave the system on for optimum performance; it does not pose a safety hazard.
The following are hazards to your safety:
■ The power cord is damaged or frayed.
■ Liquid is spilled into the system.
■ The system is exposed to water.
If any of these conditions occur, do the following:
1. Turn off the system immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative.
Caution: To reduce the risk of fire, use only No. 26 American Wire Gauge (AWG) or larger
telecommunication line cord.
Maintenance Safety
■ Do not attempt any maintenance procedure that is not specifically described in the
documentation supplied with your system.
■ Do not use aerosol cleaners. The use of supplies that are not approved may cause poor
performance and could create a hazardous condition.
■ Do not burn any consumables or routine maintenance items. For information on Xerox
supplies recycling programs, go to www.xerox.com/gwa
.
To Next Page
Loading...
Need help?
General
