Xerox WorkCentre 4118 User Manual

Xerox WorkCentre 4118 System Administration Guide Page 2-11
Basic Network Installation
Workstation Setup
To enable the workstation environment to communicate with the WorkCentre 4118 perform
the following steps:
¾ At the client workstation, install print drivers and map to the printer (see Workstation Setup
4-3).
¾ Continue with Test Print on page 2-11.
Test Print
To ensure the WorkCentre 4118 has been installed on the network correctly a test print should
be submitted from a client workstation. Perform the following steps:
¾ Ensure the print driver is installed on every workstation that will be sending jobs to the
device.
¾ Open a document on a client workstation.
¾ Select the WorkCentre 4118 as the printer for sending documents to.
¾ Print the document on the device and verify that it prints correctly.
¾ Repeat the test for all workstations that will be sending jobs to the device.
If the test print fails, refer to the Problem Solving chapter for trouble-shooting procedures.
1
2
1
2
3
4
5

Xerox WorkCentre 4118 Specifications

General

Brand	Xerox
Model	WorkCentre 4118
Category	All in One Printer
Language	English