Xerox WorkCentre 4118 User Manual

Xerox WorkCentre 4118 System Administration Guide Page 6-5
Advanced TCP/IP Setup
Enabling/Disabling Raw Printing
This procedure is used to enable or disable the Raw Printing port on the WorkCentre 4118.
Once the port is enabled, you can change the Raw Printing port number.
NOTE: While you can change the port number at which the WorkCentre 4118 will
accept RAW print jobs, it is recommended that you use the default port, 9100. this is
the industry standard. To change Port number see “Using CentreWare Internet
Services” on page 7-3.
To enable the Raw Printing port, at the WorkCentre 4118, perform these steps:
¾ Ensure the basic TCP/IP settings have been made (see “Basic TCP/IP Settings” on page
2-5).
¾ Press the [Machine Status] button.
1
2
3
¾ Press or until System
Admin Tools displays and press
[Enter].
¾ If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]
4
¾ Press or until Network
Setup displays and press [Enter].
System Admin Tools
[Network Setup]

Xerox WorkCentre 4118 Specifications

General

Brand	Xerox
Model	WorkCentre 4118
Category	All in One Printer
Language	English