DMU-2000 DATA MANAGEMENT UNITPage 30
ABOUT THE LOG BOOK
LOG BOOK FUNCTION
[
F1
(
FUNC
)]
Key
You may use the “CHECK” function to check the log
to see if a QSO has been made previously with the
logged station, and you may also create a summary of
QSOs by band and mode by pressing this key. The log
may be viewed solely for the current operator, or for
all operators registered into the Logbook and saved
on the CF card.
[
F2
(
)]
Key
Press this key to shift to the log line below the cur-
rent one.
[
F3
(
)]
Key
Press this key to shift to the log line above the cur-
rent one.
[
F4
(
EDIT
)]
Key
Press this key to enable editing of previously-stored
log data.
[
F7
(
SAVE/LOAD
)]
Key
Press this key to engage the screen that allows you to
manage log data to be saved.
[
DISPLAY
]
Key
Press this key momentarily to switch the Function
key’s function between the “Page Select Key” and the
“Function Key.”
Press and hold in this key to disable the Function keys
(except this key).
By connecting your keyboard (not supplied) to the Data
Management Unit’s rear-panel KEYBOARD jack (PS/2
or USB), you can create a Log Book within the radio, and
display it on the Display. Date, time, frequency, and mode
will be automatically stored, and you can save log data to
the Compact Flash card for archive purposes.
If the “Log Book” screen does not initially appear, press
the
[
DISPLAY
]
key to switch the Function key’s function
to “Page Select Key,” then press the
[
F4
(
LOGBOOK
)]
key momentarily to display the “Log Book” screen. Next,
press the
[
DISPLAY
]
key again to switch the Function
key’s function to the “Function Key.”
EXPLANATION OF THE FUNCTION KEYS ON THE LOG BOOK SCREEN
To Next Page
Loading...
Need help?
General
