DMU-2000 DATA MANAGEMENT UNITPage 46
MEMORY MODE
It is possible to rotate the antenna automatically to a direction or directions which you store into memory in advance.
Use of a Yaesu Rotator (G-800DXA, G-1000DXA, or G-2800DXA) requires the connection of the optional T9101556
cable to the connector located on the back of the FT-2000 transceiver.
G
REA T
C
IRCLE
M
AP
/ R
OT A TOR
C
ONTROL
FUNCTION
PROGRAMMING BEAM HEADINGS INTO MEMORY
1. Press the
[
F4
(
MODE
)]
key, as necessary, to select
the “PRESET” or “MANUAL” mode.
2. Use the techniques learned previously to rotate the
antenna to the desired beam heading.
3. Now press the
[
F4
(
MODE
)]
key to select the
“MEMORY” mode.
4. Select the desired memory channel register by using
the
[
F2
(
)]
key and
[
F3
(
)]
keys, then press the
[
F6
(
MW
)]
key to memorize the programmed beam
heading.
Advice: The maximum number of beam-heading memo-
ries which can be stored is 9.
If you have connected your after-market keyboard to the
DMU-2000, you can append a name (tag) to the memory
channel (maximum: 6 characters). It often is convenient
to enter the callsign of a station, or perhaps a label such
as “Europe” for easy reference. The method of entering
the name tag into a memory is described below.
1. Use the
[
F2
(
)]
key and
[
F3
(
)]
keys to select the
rotator memory register onto which you wish to ap-
pend a name tag.
2. Press the keyboard’s
[
ENTER
]
key; the cursor on the
screen will blink.
3. Use your keyboard to enter the name tag; a maximum
of six characters may be utilized.
MEMORY RECALL
1. Use the
[
F2
(
)]
key and
[
F3
(
)]
keys to select the
desired location from the rotator memory list.
2. When you momentarily press the
[
F5
(
MR/ERASE
)]
key, the rotator will turn to the direction (beam head-
ing) that has been memorized.
ERASING MEMORY
1. Use the
[
F2
(
)]
key and
[
F3
(
)]
keys to select the
rotator memory you wish to erase.
2. Press the
[
F5
(
MR/ERASE
)]
key for 2 seconds to
erase the memory’s data.
Note: Once erased, memory data cannot be restored!
“REGULAR COMPASS” D ISPLAY
“GREAT CIRCLE MAP” DISPLAY
To Next Page
Loading...
Need help?
General
