DMU-2000 DATA MANAGEMENT UNIT Page 47
ABOUT THE MEMORY CHANNEL LIST
USING THE MEMORY CHANNEL LIST
[
F2
(
LOAD
)]
Key
Press this key to load memory data previously saved
on the CF card to the transceiver.
[
F3
(
SAVE
)]
Key
Press this key to save the current memory data to the
CF card.
[
F5
(
MASK/RESTORE
)]
Key
It is possible to erase the currently-selected memory
channel’s data by pressing this key. If you want to re-
store the erased memory data, press this key again
after erasing the memory.
[
F6
(
)]
Key
Use this key to move the highlighted field on the
memory list downward.
[
F7
(
)]
Key
Use this key to move the highlighted field on the
memory list upward.
[
DISPLAY
]
Key
Press this key momentarily to switch the Function
key’s function between the “Page Select Key” and the
“Function Key.”
Press and hold in this key to disable the Function keys
(except this key).
This is the screen which displays the FT-2000
transceiver’s memory channels. On the list, the channel
number, ID tag, frequency, and operating mode are shown.
The FT-2000 has an extensive memory system of 99
channels that may be arrayed into up to six groups, and
you can check the entire memory system’s status by view-
ing this screen.
If the “Memory Channel List” screen does not initially
appear, press the
[
DISPLAY
]
key to switch the Function
key’s function to “Page Select Key,” then press the
[
F7
(
MCH LIST
)]
key momentarily to display the
“Memory Channel List” screen. Next, press the
[
DIS-
PLAY
]
key again to switch the Function key’s function to
the “Function Key.”
EXPLANA TION OF THE FUNCTION KEYS ON THE MEMORY CHANNEL LIST SCREEN
To Next Page
Loading...
Need help?
General
