Yaesu FT-450 User Manual

Name: Yaesu FT-450
Brand: Yaesu
Rating: 4 (1 reviews)

104 pages

To Next Page

To Previous Page

Page 9FT-450 OPERATION MANUAL

UPPLIED

MH-67A8J M

ICROPHONE

PTT Switch

Press this switch to transmit,

and release it to receive after

your transmission is com-

pleted.

MIC

The microphone is located

here. Speak into the micro-

phone in a normal voice level.

The microphone should be po-

sitioned within 2 inches (5 cm)

from the mouth for optimum

performance.

Table of Contents2
General Feature3
Front Panel Switches and Knobs4
Display Indications9
Rear Panel Jacks10
Supplied11
- Microphone11
Accessories & Options12
Installation13
- Connestion of Antenna and Power Supply13
- About Coaxial Cable13
- Grounding14
- Vl-1000 Linear Amplifier Interconnections15
- Interfacing to Other Linear Amplifier15
Easy Operation17
- How to Use the [ Dsp/Sel ] Knob17
- Menu Operation17
- How to Use the [ Voice/C.s ] Switch18
- Key Duration Setting19
- Resetting the Microprocessor20
Receiving21
- Tuning Steps21
  - Change the Tuning Step21
    - Of the [ Main Dial ] Knob21
    - Of the [ Dsp/Sel ] Knob21
  - Of the Optional Mh-31A8J and MD-100A8X22
- Clarifier22
- Digital Voice Announcement23
- Dial Lock23
- My Bands Operation24
- My Modes Operation25
- Digital Voice Recorder26
Convenience Features27
- Receiver Operation (Front End Block Diagram)27
- Att/Ipo28
  - (Adjust the Receiving Sensitivity)28
- Noise Blanker28
- (INTERFERENCE REJECTION "SIGNALS WITHIN 3 Khz")28
  - (Tool for Comfortable and Effective Reception)29
  - (INTERFERENCE REJECTION "SIGNALS WITHIN 3 Khz")30
- Shift31
- (INTERFERENCE REJECTION "SIGNALS WITHIN 3 Khz")31
- Width32
- (INTERFERENCE REJECTION "SIGNALS WITHIN 3 Khz")32
- Notch33
- (INTERFERENCE REJECTION "SIGNALS WITHIN 3 Khz")33
- Dnr34
- (INTERFERENCE REJECTION "SIGNALS WITHIN 3 Khz")34
- Rf Gain35
Ssb/Am Mode Transmission36
- Tx Meter Selection37
- Tx Power Adjustment37
- Transmitter Time-Out Timer (Tot)38
- Microphone Gain Level Adjustment39
- Dsp Microphone Equalizer40
- Automatic Tx/Rx Switching Using Voice Control (Vox)41
- Monitor42
- Split-Frequency Operation43
- Quick Split Operation43
- Voice Memory (Ssb/Am/Fm Modes)44
Cw Mode Operation46
- Setup for Straight Key46
- (And Straight Key Emulation) Operation46
- Using the Built-In Electronic Keyer47
- Cw Spotting (Zero-Beating)49
- Using Cw Reverse49
- Cw Delay Time Setting50
- Cw Sidetone Volume Level Setting50
- Cw Pitch Adjustment51
- Cw Training Feature51
- Beacon Feature52
Fm Mode Operation54
- Basic Operation54
- Repeater Operation55
- Tone Squelch/Dcs Operation56
- Tone Search Scanning57
- Convenient Memory Functions58
Memory Operation59
- Memory Groups59
- Regular Memory Operation60
- Home Channel Memories64
  - Home Channel Recall64
  - Home Channel Frequency Change64
- Qmb (Quick Memory Bank)65
  - Storage65
  - Recall65
Scanning Operation66
- Vfo and Memory Scanning66
  - Preparation66
  - Vfo/Memory Scan67
Programmable Memory Scanning68
- (Pms)68
OPERATION on ALASKA EMERGENCY FREQUENCY: 5167.5 Khz69
- (U.s. Version Only)69
Miscellaneous Settings70
- Display Setting70
- Beeper Setting71
  - Beep Volume71
  - Beep Tone72
- Automatic Power-Off (Apo)73
Rtty (Radio Teletype) Operation74
- Setting up for Rtty Operation74
- Basic Setup74
Packet Operation75
- Packet Setup75
- (Including Subcarrier Frequency)75
- Basic Setup75
Miscellaneous Afsk-Based76
- Data Modes76
Menu Mode78
- Using the Menu78
- Menu Mode Reset78
Cloning88
Installation of89
- Optional Accessories90
- Automatic Antenna Tuner90
- Operation90
- Automatic Antenna Tuner92
- Operation92
- Automatic-Matching 200-Memory94
- Antenna Tuner Fc-40 Operation94
- (Atas-100/-120/120A) Operation96
- Carrying Handle Mhg-1 Installation98
- Installation99
Specifications100

Other manuals for Yaesu FT-450

Technical Supplement69 pages

User Manual32 pages

Brochure & Specs2 pages

Questions and Answers:

Need help?

Do you have a question about the Yaesu FT-450 and is the answer not in the manual?

Yaesu FT-450 Specifications

General

Impedance	50 ohms
Supply Voltage	13.8 V DC
Supply Voltage Tolerance	±15%
Image Rejection	70 dB or better
Frequency Range Receive	30 kHz - 56 MHz
Modes	SSB, CW, AM, FM
AM Power Output	25 W
Weight	3.6 kg
Receiver Sensitivity SSB	0.2 µV (12 dB SINAD)

Related product manuals

FT-450 - CAT OPERATION REFERENCE BOOK

Yaesu FT-450 User Manual

Table of Contents

Other manuals for Yaesu FT-450

Questions and Answers:

Yaesu FT-450 Specifications

Related product manuals