Yaesu FT-450 User Manual

Page 96 FT-450 OPERATION MANUAL
I NSTALLATION OF O PTIONAL A CCESSORIES
CARRYING HANDLE MHG-1 INSTALLATION
The MHG-1 is a Carrying Handle designed to match FT-450 transceiver.
Parts List
Handle ................................................................ 1pc
Handle end ....................................................... 2pcs
Mounting Screws (M4x15B) ............................. 2pcs
Installation
Screw the Carrying Handle to the FT-450 using the
supplied screws.
Do not install the supplied MHG-1 Mounting
Screws if you are not installing the MHG-1!
Also, do not use an improper screw for mount-
ing the MHG-1! An improper screw may cause
a “short circuit” to the internal circuitry, caus-
ing serious damage!
Handle
Handle end
(2 pcs)
Mounting Screws
(2 pcs)

Yaesu FT-450 Specifications

General

Impedance	50 ohms
Supply Voltage	13.8 V DC
Supply Voltage Tolerance	±15%
Image Rejection	70 dB or better
Frequency Range Receive	30 kHz - 56 MHz
Modes	SSB, CW, AM, FM
AM Power Output	25 W
Weight	3.6 kg
Receiver Sensitivity SSB	0.2 µV (12 dB SINAD)