Yaesu FT-450 User Manual

Page 60 FT-450 OPERATION MANUAL
M EMORY O PERATION
Labeling Memories
You may wish to append an Alphanumeric “Tag” (label) to a memory or memories, to aid in recollection of the
channel’s use (such as a club name, etc.). This is easily accomplished using the Menu mode.
REGULAR MEMORY OPERATION
1. Press and hold the
[
F
]
button for one second to
enter the Menu mode. The “
” icon will ap-
pear on the display.
2. Rotate the
[
DSP/SEL
]
knob to select the menu
item “EXT MNU”.
3. Press the
[
DSP/SEL
]
knob to enable adjustment
of this menu item. The “
” icon will be blink-
ing.
4. Rotate the
[
DSP/SEL
]
knob to select “ON” to ex-
pand the menu items.
5. Press the
[
DSP/SEL
]
knob. The “
” icon re-
turns to appear continuously.
6. Press and hold the
[
F
]
button for one second to save
the new setting and return to normal operation.
7. Recall the memory channel that you wish to ap-
pend a label.
8. Press and hold the
[
F
]
button for one second to
enter the Menu mode again. The “
” icon
will appear on the display.
9. Rotate the
[
DSP/SEL
]
knob to select the menu
item “MEM TAG”.
10.Press the
[
DSP/SEL
]
knob to enable adjustment
of this menu item. The “ ” icon will blink,
and “MEM TAG” will be replaced with “TAG-OFF”
11. Press the [F] button to display the previously stored
label (in the factory default, all memory channels
are stored with the memory channel number as
the label).
12.Rotate the
[
MAIN DIAL
]
knob to select the first
digit of the desired label.
13.Rotate the
[
DSP/SEL
]
knob one step clockwise
to move to the next character.
14.Repeat steps 12 and 13 to program the remain-
ing letters, numbers, or symbols of the desired
label. Seven characters may be used in the cre-
ation of a label.
15.If you make a mistake, rotate the
[
DSP/SEL
]
knob
counter-clockwise to move back the cursor, then
re-enter the correct letter, number, or symbol.
You may press the [CLAR] button to clear the cur-
rent digit label.
16.When you have completed the creation of the la-
bel, press the
[
DSP/SEL
]
knob. The “ ” icon
returns to appear continuously.
17.Press and hold the
[
F
]
button for one second to
save the new setting and return to normal opera-
tion.
In Memory mode operation, the display indicates the
channel numbers while selecting the memory chan-
nels, then the display will switch to the Alphanumeric
“Tag” (label) after two seconds.
[
DSP/SEL
]
Knob
[
MW/V/M
]
button
[
F
]
button
[
MAIN DIAL
]
Knob
[
CLAR
]
button

Yaesu FT-450 Specifications

General

Impedance	50 ohms
Supply Voltage	13.8 V DC
Supply Voltage Tolerance	±15%
Image Rejection	70 dB or better
Frequency Range Receive	30 kHz - 56 MHz
Modes	SSB, CW, AM, FM
AM Power Output	25 W
Weight	3.6 kg
Receiver Sensitivity SSB	0.2 µV (12 dB SINAD)