Log Function
Digital LCD
expanded analogue LED
pointer (once round per
knot)
Primary Functions:
Primary Display Functions are selected in
sequence by briefly pressing the SELECT
button.
2
Average Speed
➤
➤
Trip Time
Trip Distance
Trip distance is regis-
tered up to 999,9 NM. It
can be cleared with the
left button or it is cleared
automatically, when
TRIP TIME starts ei-
ther manually or after
the race timer has
counted down to
zero.
Trip distance is a
local function and
may be running
independently on
various displays.
The left button has the
following Function:
Stop, Reset, set minus
5 or minus 10 minutes.
The timer is started
with the right button.
The Display shows
minutes and sec-
onds (up to one
hour) and hours and
minutes (for more
than one hour).
Trip Time is a local
Function.
Boat Speed
Temperature
Water Tempera-
ture is sensed at the
Log Sensor.
Dashes are dis-
played in case of an
open sensor circuit
(eventually verify
correct Sensor Type
SE=.. in the display
configuration).
Average Speed is
calculated from TRIP
TIME and TRIP DIS-
TANCE.
Average speed is
not calculated, when
the timer is halted
(display = zero).
Average Speed is
a local function and
may be different on
every Display unit.
Secondary Functions:
The Secondary Display Functions can be
accessed by holding the SELECT button for
two seconds for the first function and then
briefly pressing it for all other functions.
After the last Secondary Function follows
again the first Primary Display Function.
Actual water speed in
knots. Replaced by GPS-
Speed in case there is no
Log Sensor in the system.
The analog LED pointer
is expanded to once
round per knot.
If desired, the
LED can be config-
ured OFF and the
speed averaged
over 15 seconds by
selecting dF=24
instead od dF=20 in
the configuration menu.
To Next Page
Loading...
Need help?
General
