5
Load Sensor
Rig Load Display
Rig Load is displayed
from zero to 49.9 kiloNe-
wton (4.99t). Different
scales are available upon
request.
Sensors from vari-
ous suppliers can be
connected (Navtec,
B&G).
Installation:
A Tecnautic Load
Sensor Interface
must be connected
between the sensor and
the cockpit display. The in-
terface can be calibrated for any particular
sensor.
The display unit to which the Load Sensor
is connected, has to be configured with sen-
sor number SE=14.
At all display units, where the Rig Load
Reading shall be enabled, function number
dF=28 must be activated.
➤
➤
Sensor Cable:
6 pin plug RJ-11 (4 pins installed)
6 pin plug, 4-wire cable:
pin round flat-oval
# cable cable
1 ----- ----- unused
2 white white +5 Volts
3 brown blue GND
4 yellow cyan Sensor signal
5 green magenta reserved
6 ----- ----- unused
pin 1 and 6 must remain
unconnected
Important in case of third party
sensor electronics:
All sensors (including their associated elec-
tronics) must only be wired to the display unit
via its sensor cable. No other electric connec-
tion between sensor and boat must exist. That
means only the supply from the display (GND
and +5 Volts) may be used. The current drawn
should not exceed 25 mA and should be
steady (+/- 1mA).
Pin #1
white lead onto pin
#2
To Next Page
Loading...
