To Next Page

To Previous Page

3 - 14

CHK

ADJ

ADJUSTING THE VALVE CLEARANCE/

SYNCHRONIZING THE THROTTLE BODIES

g. Measure the valve clearance again.

h. If the valve clearance is still out of

specification, repeat all of the valve

clearance adjustment steps until the

specified clearance is obtained.

▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲

8. Install:

• all removed parts

NOTE:

For installation, reverse the removal

procedure. Note the following points.

SYNCHRONIZING THE THROTTLE BODIES

NOTE:

Prior to synchronizing the throttle

bodies, the valve clearance and the

engine idling speed should be properly

adjusted and the ignition timing should

be checked.

1. Stand the motorcycle on a level surface.

NOTE:

Place the motorcycle on a suitable

stand.

2. Remove:

• fuel tank

Refer to “FUEL TANK AND AIR FIL-

TER”.

• bottom cowling

• front cowling

Refer to “COWLINGS”.

3. Remove:

• bolts 1

• copper washers

Yamaha YZFR7P User Manual

Other manuals for Yamaha YZFR7P