CLUTCH
EB405703
INSTALLING THE CLUTCH
1. Install:
• clutch housing
NOTE:
• Make sure that the slots a in the
clutch housing align with the tabs b
on the oil/water pump assembly drive
sprocket.
• Make sure that the primary driven gear
teeth and primary drive gear teeth
mesh correctly.
• Make sure that the starter clutch gear
teeth and starter clutch idle gear teeth
mesh correctly.
2. Install:
• back torque limiter inner boss 1
• back torque limiter bearing 2
• back torque limiter outer boss 3
ACHTUNG:
CAUTION:
Be sure that the back torque limiter
bearing is installed facing in the correct
direction as shown.
3. Install:
• lock washer
• clutch boss nut 1
NOTE:
While holding the clutch boss 2 with
the clutch holding tool 3, tighten the
clutch boss nut.
Clutch holding tool
90890-04086
New
T
R
.
.
70 Nm (7.0 m · kg, 50 ft · lb)
To Next Page
Loading...
Need help?
General
