3 - 24
CHK
ADJ
CHANGING THE ENGINE OIL
EB303081
CHANGING THE ENGINE OIL
1. Remove:
• bottom cowling
• front cowling
Refer to “COWLINGS”.
2. Start the engine, warm it up for several
minutes, and then turn it off.
3. Place a container under the engine oil
drain bolt.
4. Remove:
• engine oil filler cap 1
• engine oil drain bolt 2
(along with the washer)
5. Drain:
• engine oil
(completely from the crankcase)
1
1
6. If the oil filter cartridge is also to be
replaced, perform the following proce-
dure.
▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼
a. Remove the oil filter cartridge 1 with
an oil filter wrench 2.
Oil filter wrench
90890-01426
b. Lubricate the O-ring 3 of the new oil
filter cartridge with a thin coat of
engine oil.
ACHTUNG:
CAUTION:
Make sure that the O-ring 3 is posi-
tioned correctly in the groove of the oil
filter cartridge.
c. Tighten the new oil filter cartridge to
specification with an oil filter wrench.
▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲
7. Check:
• engine oil drain bolt washer
Damage → Replace.
8. Install:
• engine oil drain bolt
T
R
.
.
Oil filter cartridge
17 Nm (1.7 m • kg, 12 ft • lb)
T
R
.
.
43 Nm (4.3 m · kg, 31 ft • lb)