3 - 28
CHK
ADJ
BLEEDING THE HYDRAULIC CLUTCH SYSTEM/
CLEANING THE AIR FILTER ELEMENT
j. Tighten the bleed screw to specifica-
tion.
k. Fill the clutch fluid reservoir to the
proper level with the recommended
clutch fluid.
Refer to “CHECKING THE CLUTCH
FLUID LEVEL”.
WARNING
WARNING
After bleeding the hydraulic clutch sys-
tem, check the clutch operation.
▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲
T
R
.
.
Bleed screw
6 Nm (0.6 m • kg, 4.3 ft • lb)
EB303130
CLEANING THE AIR FILTER ELEMENT
1. Remove:
• fuel tank
• air filter case cover
• air filter element
Refer to “FUEL TANK AND AIR FIL-
TER”.
2. Clean:
• air filter element
Apply compressed air to the outer sur-
face of the air filter element.
3. Check:
• air filter element
Damage → Replace.
4. Install:
• air filter element
• air filter case cover
ACHTUNG:
CAUTION:
Never operate the engine without the
air filter element installed. Unfiltered air
will cause rapid wear of engine parts
and may damage the engine. Operating
the engine without the air filter element
will also affect the electronic fuel injec-
tion, leading to poor engine perfor-
mance and possible overheating.
5. Install:
• fuel tank
Refer to “FUEL TANK AND AIR FIL-
TER”.
To Next Page
Loading...
Need help?
General
