| Configuring Call Settings | 220
Muting Auto-Answered Calls
The Auto Answer Mute feature avoids the caller hearing the local conversation freely when an incoming call
is answered automatically. Enable the local microphone to be muted when an incoming call is answered
automatically.
About this task
Only the Auto Answer Mute feature is enabled can this feature be available.
Procedure
1. Do one of the following:
• On your web user interface, go to Call Features > Call Features > Inbound Call Settings.
• On your VCS, go to More > Settings > Basic > Call Features.
For VP59, tap > Settings > Basic > Call Features.
•
On your CTP20/CTP18, tap > Settings > Basic > Cal Features.
2. Enable or disable Auto Answer Mute.
3. Save the change.
Related information
Auto Answer
Muting Auto-Dialed Calls
The Auto Dialout Mute feature allows the endpoint to turn off the microphone after the other party answers
your call. Therefore, other party cannot hear you.
About this task
Note: The system is still muted after you hang up.
Procedure
1. On your web user interface, go to Setting > Call Features > Outbound Call Settings.
2. Enable or disable Auto Dialout Mute.
3. Save the change.
DND (Do Not Disturb)
You can enable do not disturb feature to reject incoming calls automatically. All the rejected calls will be
recorded to the missed call list.
• Enabling DND When Not in a Call
• Enabling DND during an Active Call
To Next Page
Loading...
Need help?
General
