5-3
IM WT5000-02EN
5.2 Displaying Harmonic Measurements (numeric
display)
This instrument shows on the screen the harmonic measurements (measurement functions) of the
voltage and current applied to the input elements or wiring units.
Using an example, this section explains how to display harmonic measurements numerically.
In addition, this section explains operating procedures using the following setup methods.
• Procedure Using the Setup Menu (see chapter 1)
• Procedure Using the Menu Icons (see page iii)
Measurement Display Screen (Example of a 4 items display)
Measurement display of input element 1
Measured harmonic voltage (50th harmonic) Measured harmonic power (50th harmonic)
Measured harmonic current
(50th harmonic)
Measured harmonic power factor (50th harmonic)
Switches the displayed page (Page Up/Page Down)
Switches to the measurement display of another input element
Tap ▲ or ▼ to change the displayed page in order from the
current number. Tap the number directly to change to the
number display page.
If you hold your finger down on the 4-,
8-, 16-value, matrix or harmonics
display for at least 1 second, you can
perform the operations described in
“Switching the Displayed Items (Items),”
Note
Harmonic measurements can be shown graphically.
• The trend display (see section 6.3) shows harmonic measurements graphically.
• The bar graph display (see section 6.4) shows the magnitude of each harmonic graphically.
• The vector display (see section 6.5) shows the phase difference and the magnitude relationship between
fundamental waves U(1) and I(1) of each element in the wiring unit.
To Next Page
Loading...
Need help?
General
