3-14
IM WT5000-02EN
3.4 Displaying the Phase Difference And
Frequency (Voltage and Current)
This instrument shows on the screen the measurements of the phase differences and frequencies of
the voltage and current applied to the input elements or wiring units.
► “Phase Difference Polarity (Phase Polarity)” in the features guide
► “Phase Difference Display Format (Phase Angle)” in the features guide
The measurements of phase difference and frequency do not require you to set equations. The
measurements are simply shown on the screen. Using an example, this section explains how to
display measurement results numerically.
In addition, this section explains operating procedures using the following setup methods.
• Procedure Using the Setup Menu (see chapter 1)
• Procedure Using the Menu Icons (see page iii)
Measurement Display Screen (Example of a 4 items display)
Measurement display of input element 1
Measured phase difference between
voltage and current
Measured frequency (current)
Measured frequency (voltage)
Switches the displayed page (Page Up/Page Down)
Switches to the measurement display of another input element
Tap ▲ or ▼ to change the displayed page in order from the
current number. Tap the number directly to change to the
number display page.
If you hold your finger down on the 4-,
8-, 16-value, matrix or harmonics
display for at least 1 second, you can
perform the operations described in
“Switching the Displayed Items (Items),”
Note
Phase difference and frequency (voltage and current) values can be shown graphically.
• The trend display (see section 6.3) shows phase difference and frequency (voltage and current) values
graphically.
To Next Page
Loading...
Need help?
General
