9-1
IM WT5000-02EN
Chapter 9 Motor Evaluation and Auxiliary Input (Option)
9.1 Configuring Motor Evaluation and Auxiliary
Input Settings
► “Motor Evaluation/Auxiliary Inputs (Motor/Aux)” in the features guide
This section explains operating procedures using the following setup methods.
• Procedure Using the Setup Menu (see chapter 1)
Procedure Using the Setup Menu
1.
Tap the Setup icon , or press MENU under SETUP.
2.
Tap the Input (Advanced/Options) tab. An input settings (advanced/options) overview screen
appears.
Pressing ESC closes the overview screen.
Configuring Motor Evaluation and Auxiliary Input Settings (Motor/
Aux)
3.
Tap Motor/Aux. A motor evaluation/auxiliary input setup screen appears.
The following screen is an example for a model with the /MTR2 option.
Motor/Aux button
/MTR1 options screen
/MTR2 options screen
Set the MTR configuration (device to be evaluated).
(Single Motor (Speed: Pulse), Single Motor (Speed: Analog), Double Motor, Auxiliary)
Input (Advanced/Options) tab
Turns electrical
angle measurement
on or off
Configure the electrical angle measurement.
You can use these when the electrical angle measurement is on.
A connection diagram of revolution signal and torque signals appears according to
the MTR configuration.
Set Motor/Aux.
Note
• You can configure the Motor1 and Motor2 settings on models with the /MTR1 option and the Motor1 to
Motor4 settings on models with the /MTR2 option.
• You can also display the input settings overview screen by moving the cursor on the Input (Advanced/
Options) tab using the arrow keys and then pressing SET.
To Next Page
Loading...
Need help?
General
