16-8
IM WT5000-02EN
16.6 Environment Settings (Preference)
► “Environment Settings (Preference)” in the features guide
This section explains operating procedures using the following setup methods.
• Procedure Using the Setup Menu (see chapter 1)
• Procedure Using the Keys (other than SETUP) (see section 1.2 in IM WT5000-03EN)
Procedure Using the Setup Menu
1.
Tap the Setup icon , or press MENU under SETUP.
2.
Tap the Utility tab. The utility settings overview screen appears.
Pressing ESC closes the overview screen.
Environment Settings (Preference)
3.
Tap System Configuration. A system setup (Date/Time, Language, LCD, Preference) appears.
Utility tab
Configure the system.
LCD
(See section 16.5.)
Language screen
(See section 16.4.)
Set the frequency display value
when the measured frequency is
less than the lower limit (0, Error).
On models with the /MTR option, set the motor display value when
the measured pulse frequency is less than the lower limit (0, Error).
Set the decimal point and separator to
use when data is saved in ASCII format
as a .CSV file (Period, Comma).
Set the rounding
to zero (OFF, ON).
See section 16.4.
Note
You can also display the utility settings overview screen by moving the cursor on the Utility tab using the
arrow keys and then pressing SET.
Procedure Using Keys
See section 16.1.
To Next Page
Loading...
Need help?
General
