9-13
IM WT5000-02EN
Procedure Using the Setup Menu
1.
Tap the Setup icon , or press MENU under SETUP.
2.
Tap Computation/Output tab. A computation and output settings overview screen appears.
Pressing ESC closes the overview screen.
Switching the Displayed Items (Items)
You can switch the measured value (measurement function) shown in the screen.
3.
Tap Display.
A display format setup screen (Numeric/Graph) appears. For details, see section 3.1.
4.
Tap Items. The following screen appears.
Closes the menu
Set the displayed item.
You can set the following items for displaying motor evaluation.
• Motor evaluation (Motor group):
Speed (motor rotating speed), Torque (motor torque),
SyncSP (sync speed), Slip (slip (%)),
Pm (Motor mechanical output (mechanical power)),
EaM1U1 to EaM1U7
(electrical angle: phase angles of U1 to U7 relative to the falling edge of the
Speed1 signal’ s Z phase input),
EaM3U1 to EaM3U7
(electrical angle: phase angles of U1 to U7 relative to the falling edge of the
Speed3 signal’ s Z phase input),
EaM1I1 to EaM1I7
(electrical angle: phase angles of I1 to I7 relative to the falling edge of the
Speed1 signal’ s Z phase input),
EaM3I1 to EaM3I7
(electrical angle: phase angles of I1 to I7 relative to the falling edge of the
Speed3 signal’ s Z phase input)
• Efficiency (Efficiency group):
Procedure Using the Menu Icons
You can also use the menu icons shown on the right side of the screen to switch the displayed items.
1.
Tap the Display menu icon . A Display menu appears in the sub menu area on the right side
of the screen.
By tapping the displayed items, you can specify the same settings as when using the screen explained
earlier.
Note
For details on the Display menu, see page iv.
9.2 Displaying the Motor Evaluation (numeric display)
To Next Page
Loading...
Need help?
General
