Introduction
13
Unpack and Inspect the Printer
When you receive the printer, immediately unpack it and inspect for shipping damage.
• Save all packing materials.
• Check all exterior surfaces for damage.
• Open the printer and inspect the media compartment for damage to components.
If you discover shipping damage upon inspection:
• Immediately notify the shipping company and file a damage report. Zebra Technologies Corporation
is not responsible for any damage to the printer incurred during shipment, and will not cover the
repair of this damage under its warranty policy.
• Keep all packaging material for shipping company inspection.
• Notify your authorized Zebra
®
reseller.
See the Zebra Web site for ‘How To’ videos on packing and unpacking your printer. Use this link to get to
your Online printer support resources:
ZD200 Series Thermal Transfer Printer — www.zebra.com/zd200t-info
Opening and Closing the Printer
Open: To access the media compartment, pull the release latches towards you and lift the cover. Check
the media compartment for loose or damaged components.
Close: Lower the top cover. Press down in the middle of the cover in front until the cover snaps closed.
ESD Caution • The discharge of electrostatic energy that accumulates on the surface of the human body or other
surfaces can damage or destroy the printhead and other electronic components used in this device. You must observe
static-safe procedures when working with the printhead or the electronic components under the top cover.
Opening Closing
To Next Page
Loading...
Need help?
General
