Setup
24
Attaching Power
Caution • Never operate the printer and power supply in an area where they can get wet. Serious personal injury could
result!
Note • Set up your printer so that you can handle the power cord easily if needed. Some processes for setup or
troubleshooting issues may ask you to remove power. Separate the power cord from the power supply receptacle or
AC electrical outlet to make certain the printer cannot carry electrical current.
1. Plug the power supply into the printer’s DC power receptacle.
2. Insert the AC power cord into the power supply.
3. Plug the other end of the AC power cord into an appropriate AC electrical outlet. Note that AC outlet
end of the power cord’s plug type can vary by region.
4. The active power light will turn on green if power is on at the AC outlet.
Important • Ensure the appropriate power cord with a three (3) prong plug and an IEC 60320-C13 connector are used
at all times. These power cords must bear the relevant certification mark of the country in which the product is being
used.
p
To Next Page
Loading...
Need help?
General
