Setup
27
Instructions for media loading:
This procedure works for Tear-Off (standard bezel), Label Dispense and Media Cutting printer options.
1. Open the printer. Pull the release latch levers toward the front of the printer.
2. Open the media roll holders. Orient the media roll so that its printing surface will face up as it passes
over the platen (drive) roller. Pull the media guides open with your free hand and place the media roll on
the roll holders and release the guides. Verify the roll turns freely. The roll must not sit in the bottom of
the media compartment.
To Next Page
Loading...
Need help?
General
