Print Operations
75
3. Insert the media through the slot at the rear of the printer and place the media between the media guide
and roll holders.
4. Close the top cover.
After printing or using the FEED button to advance several labels: If the media does not track down
the center (moves from side to side) or the sides of the media (liner, tag, paper, etc.) are frayed or
damaged when exiting the printer, then the media guide stop position may need further adjustment.
If this does not correct the problem, then the media can be routed over the two roll holding pins on the
media guide. An empty roll core of the same width as the stack of the fan-fold media can be placed
between the roll holders to provide additional support for thin media.
To Next Page
Loading...
Need help?
General
