Zte ZXR10 User Manual

2-1
2 Overview
This chapter presents functions, features, technical characteristics and parameters of
the W140A.
2.1 Preface
The W140A outdoor AP/bridge of ZXR10 WAS (V1.0) IP wireless access system is
developed by ZTE and its design totally complies with the international standards.
The W140A uses customized antennas on the roof or a special pole for wide coverage,
enabling wireless cellular roaming in a large area.
2.2 Functions and Features
W140A complies with IEEE 802.11b Standard and is compatible with wireless network
adapters and APs complying with this standard. The features of the W140A are as
follows:
● The maximum access rate is 11 Mbps. At most 100 Stations can be accessed.
● The radio transmission power can be adjusted up to 200 mW.
● Transparent bridge connection provides packet transfer between Basic Service
Set (BSS) and Distributed System (DS). The maximum transfer rate is not less
than 10 Mbps.
● The load balance adopts the access balance with multiple APs in the same area
provided by the internal protocol.
● It provides seamless roaming to enable users to access network easily.
● It provides link integrity function, thus enhancing equipment reliability.
● ESSID provides network authentication to prevent illegal users from accessing
the network.
● Static MAC filtration can filter MAC addresses set by users. Up to 100 filtration
groups can be set and each of them can be set with 64 MAC address filtration
rules.

Zte ZXR10 Specifications

General

Product Series	ZXR10
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Switching Capacity	256 Gbps
Forwarding Performance	96 Mpps
Humidity	10% to 90% (non-condensing)