6-1
6 WEB Configuration
This chapter describes the operation methods and configuration pages of the W140A
web configuration.
6.1 Overview
For the W140A, we also provide a WEB configuration page to configure the various
parameters of the W140A. The configuration page is same as an ordinary Web page,
and the followings are some instructions on WEB configuration:
1. We provide a means to log into the W140A in the HTTP mode to configure
parameters. Users can open the WEB configuration login page of the W140A by
entering http://Working IP Address of W140A in the address bar of the WEB
browser (the default working IP address of the W140A is 192.168.1.254, and the
subnet is 255.255.255.0).
2. To simplify operation, only one operation mode is available at present for WEB
configuration (similar to the CONFIG mode in CLI configuration), with two
levels of password protection. The first level of password allows users to browse
the current parameters. To submit data for the first time after login, users must
enter the privileged user password, and it is unnecessary to re-enter the
privileged user password for submitting other data pages if the password is
correct. These two levels of passwords are same as those of the CLI
configuration.
3. Browsing and setting functions: After you logs in successfully, you can open a
certain WEB page to browse the current parameters. To modify a certain
parameter, you just need to enter the new value and then submit the modification.
If the setting operation is successful, you can view the new setting by returning
to the previous page. WEB configuration will resolve the newly entered value,
and a failure message will be returned if the format is incorrect.
4. At present, only one user is allowed to configure or browse parameters for WEB
configuration. If the user is idle for over 5 minutes, he will automatically exit
and another user can log in for configuration.
To Next Page
Loading...
Need help?
General
