128 Technical data
CE marking
A CE mark is attached to the drive to verify that the drive complies with the provisions of
the European Low Voltage and EMC Directives. The CE marking also verifies that the
drive, in regard to its safety functions (such as Safe torque off), conforms with the
Machinery Directive as a safety component.
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified according to
standard EN 61800-5-1.
Compliance with the European EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. The EMC product standard (EN 61800-
3:2004) covers requirements stated for drives. See section Compliance with the
EN 61800-3:2004 below.
Compliance with the European Machinery Directive
The drive is an electronic product which is covered by the European Low Voltage
Directive. However, the drive includes the Safe torque off function and can be equipped
with other safety functions for machinery which, as safety components, are in the scope of
the Machinery Directive. These functions of the drive comply with European harmonized
standards such as EN 61800-5-2. The declaration of conformity is shown below.
Applicable standards
The drive complies with the standards below. The compliance with the European
Low Voltage Directive is verified according to standard EN 61800-5-1.
European electrical safety requirements product standards
EN 61800-5-1:2007 Adjustable speed electrical power drive systems. Part 5-1: Safety requirements
– electrical, thermal and energy
IEC 60146-1-1:2009
EN 60146-1-1:2010
Semiconductor converters – General requirements and line commutated
converters – Part 1-1: Specification of basic requirements
IEC 60204-1:2005
+A1:2008
EN 60204-1:2006
+AC:2010
Safety of machinery. Electrical equipment of machines. Part 1: General
requirements.
Provisions for compliance: The final assembler of the machine is responsible for
installing emergency-stop device.
IEC 60529:1989
EN 60529:1991
Degrees of protection provided by enclosures (IP code)
IEC/EN 60664-1:2007 Insulation coordination for equipment within low-voltage systems. Part 1:
Principles, requirements and tests
IEC/EN 61439-1:2009 Low-voltage switchgear and control gear assemblies -- Part 1: General rules
EMC performance
EN 61800-3:2004 Adjustible speed electrical power drive systems. Part 3: EMC requirements and
specific test methods
To Next Page
Loading...
Need help?
General
