4 Repair
4.1 Introduction
Structure of this chapter
This chapter describes repair activities for the IRB 2600/IRB 2600 ID. Each
procedure contains the information required to perform the activity, for example
spare parts numbers, required special tools, and materials.
WARNING
Repair activities not described in this chapter must only be carried out by ABB.
Report replaced units
Note
When replacing a part on the IRB 2600/IRB 2600 ID, report to your local ABB the
serial number, the article number, and the revision of both the replaced unit and
the replacement unit.
This is particularly important for safety equipment to maintain the safety integrity
of the installation.
Safety information
Make sure to read through the chapter Safety on page 21 before commencing any
service work.
Note
If the IRB 2600/IRB 2600 ID is connected to power, always make sure that the
IRB 2600/IRB 2600 ID is connected to protective earth and a residual current
device (RCD) before starting any repair work.
For more information see:
• Product manual - OmniCore V250XT
• Product manual - IRC5
• Product manual - IRC5 Panel Mounted Controller
Product manual - IRB 2600 191
3HAC035504-001 Revision: AD
© Copyright 2009-2023 ABB. All rights reserved.
4 Repair
4.1 Introduction
To Next Page
Loading...
Need help?
General