6
MOTOR CONTROL AND PROTECTION UNIT M10X USER GUIDE
Related documentation
1TNC 911112 M10x User Guide
1TNC 911507 M10x-P PROFIBUS Protocol Implementation
1TNC 911505 M10x-M Modbus Protocol Implementation
1TNC 911104 MCUSetup User Guide
1TNC928239 M10x -TCP User Guide
Related System Version
The content of this document is related to M10x products (1TNA920xx) with the following hardware and
firmware version release:
HW FW
M10x-M 24VDC 2.0 3.5
M10x-M 110VAC 1.0 3.5
M10x-M 240VAC 1.0 3.5
M10x-P 24VDC 3.2 5.4
M10x-P 110VAC 1.0 5.4
M10x-P 240VAC 5.2 5.4
MD21 1.0 2.3
MD31 1.0 1.1
EM01 1.0 1.1
Revision Description of change Date
D0201 Initial Edition 10/2003
D0202 Product revisions 10/2005
D0203 Revise COM terminals; Revise terminology of
control authority. Revise earth fault setting.
10/2007
D0204 Template changed as per BU Guideline. 10/2010
D0205 Released for M10x products with new hardware,
suitable for both M10x-M and M10x-P
01/2013
D0206 Feature "Ready to start" is added to DO 07/2013
D0207 Add in Phase sequence protection and more
DO functions, modify main switch supervision
function.
09/2016
D0208 Add in insertion cycle supervision, external VT
setting and M10x-TCP with EM01 module
02/2020
Until further notice, this document is also applicable for future firmware versions other than those listed
above.
The described functions are designed but may not be fully implemented in all details. Please refer to the
release notes regarding possible restrictions.
Document revision history
To Next Page
Loading...
Need help?
General
