Operation 91
Start up assistant
The Start up assistant appears automatically when the inverter is first installed. This
menu guides the user through the settings for language, date, time and installation
country.
Note: The installation country is permanent once the setting has been confirmed. If
you need to change the installation country, contact your ABB partner for advice.
If necessary, these parameters, except for installation country, can be adjusted later.
See Start-up on page 77 for the setting procedure.
Output view menu
This menu shows the status and history of power produced by the system. In most
screens the user can toggle back and forth between numeric and graphical histogram
views to suit the user’s preference.
This is the “home” screen, from which the Menu is accessed. It is also normally the
view that appears when the inverter is powered on and it detects user interaction. The
Sun Display appears automatically when the control panel is not touched for a while
(default 3 minutes).
In multi-unit systems, it is possible to choose whether to show the combined output of
all units.
The histograms show one column per hour, day, month or year. The current column is
always shown in a different shade to the others.
Use the left and right arrow keys to choose between different time periods.
In the Output: Today view, the number in the upper right corner of the graphical
content area shows the cumulative value of energy produced during the day so far.
The number in the upper left shows the current output power in kW. If the inverter is
disconnected from the grid then “-- kW” is shown. If the inverter is connected to the
grid but is not feeding power, “0 kW” is shown.
The format (12 hour or 24 hour) of the time points below the graph initially depends
on the geographical location of the unit. The format is user selectable from the Date
and time menu.
In the Output: This week, Output: This month, Output: This year, and Output: 24
years views, the number in the upper right corner of the graphical content area
shows the cumulative value of energy that has been produced during the week,
month, year and 24 years respectively.
The Total page shows cumulative values since the unit was installed. The Energy
output and Operation time headers and values are always shown. The CO
2
reduction
header and value are shown only if a reduction factor has been set with Menu
-
>
CO2
reduction.
To Next Page
Loading...
Need help?
General