Agilent Technologies 33250A User Manual

164
Chapter 4 Remote Interface Reference
Output Configuration Commands
4
OUTPut:POLarity {NORMal|INVerted}
OUTPut:POLarity?
Invert the waveform relative to the offset voltage. In the normal mode
(default), the waveform goes positive during the first part of the cycle.
In the inverted mode, the waveform goes negative during the first part of
the cycle. The :POL? query returns “NORM” or “INV”.
• As shown in the examples below, the waveform is inverted relative to
the offset voltage. Any offset voltage present will remain unchanged
when the waveform is inverted.
• When a waveform is inverted, the Sync signal associated with the
waveform is not inverted.
OUTPut:SYNC {OFF|ON}
OUTPut:SYNC?
Disable or enable the front-panel Sync connector. At lower amplitudes,
you can reduce output
distortion by disabling the Sync signal. The default
setting is “ON”.
The :SYNC? query returns “0” (OFF) or “1” (ON).
• For more details on the Sync signal for each waveform function,
see “Sync Output Signal” on page 62.
• When the Sync signal is disabled, the output level on the Sync
connector is a logic “low” level.
• When a waveform is inverted (OUTP:POL command), the Sync signal
associated with the waveform is not inverted.
•The OUTP:SYNC command is overridden by the setting of the MARK
command used with the sweep mode (see page 186). Therefore,
when the marker frequency is enabled (and the sweep mode is also
enabled), the OUTP:SYNC command is ignored.
No Offset Voltage With Offset Voltage
Inverted
Normal
0V
I
nverte
d
0V
Normal
Offset

Agilent Technologies 33250A Specifications

General

Brand	Agilent Technologies
Model	33250A
Category	Inverter
Language	English