Alcatel-Lucent 7750 SR OS Basic User Manual

Boot Option Files
7750 SR OS Basic System Configuration Guide Page 193
speed
Syntax speed speed
Context bof
Description
This command configures the speed for the
CPM management Ethernet port when autonegotiation is
disabled in the running configuration and the Boot Option File (BOF).
If the port is configured to autonegotiate this parameter is ignored.
Default speed 100 — 100 M/bps operation.
Parameters 10 — Sets the link to 10 M/bps speed.
100 — Sets the link to 100 M/bps speed.
static-route
Syntax [no] static-route ip-prefix/ip-prefix-length next-hop ip-address
Context bof
Description
This command creates a static route entry for the
CPM management Ethernet port in the running
configuration and the Boot Option File (BOF).
This command allows manual configuration of static routing table entries. These static routes are only
used by traffic generated by the
CPM Ethernet port. To reduce configuration, manual address
aggregation should be applied where possible.
A static default (0.0.0.0/0 or ::/0) route cannot be configured on the
CPM Ethernet port. A maximum
of 10 static routes can be configured on the
CPM port.
The no form of the command deletes the static route.
Default No default routes are configured.
Parameters ip-prefix/ip-prefix-length — The destination address of the static route in dotted decimal notation.
Values ip-prefix/ip-prefix-length: ipv4-prefix a.b.c.d (host bits must be 0)
ipv4-prefix-le 0 — 32
ipv6-prefix x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0..FFFF]H
d: [0..255]D
ipv6-prefix-le 0 — 128
ip-address: ipv4-address a.b.c.d
ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0..FFFF]H
d: [0..255]D

Alcatel-Lucent 7750 SR OS Basic Specifications

General

Brand	Alcatel-Lucent
Model	7750 SR OS Basic
Category	Network Router
Language	English