Alcatel-Lucent 7750 SR OS Basic User Manual

Common Configuration Tasks
Page 258 7750 SR OS Basic System Configuration Guide
exit
A:sim1>config>system>time#
The following example in the config context shows NTP enabled with the broadcast command
configured. At this level, the NTP broadcast commands are displayed at the end of the output after
the router interfaces are shown.
A:sim1>config info
....
#--------------------------------------------------
echo "System Time NTP Configuration"
#--------------------------------------------------
system
time
ntp
broadcast interface toboth
exit
exit
exit
A:sim1>config
Broadcastclient
The broadcastclient command enables listening to NTP broadcast messages on the specified
interface.
CLI Syntax: config>system>time>ntp
broadcastclient[router router-name] {interface
ip-int-name} [authenticate]
Example
: config>system>time>ntp#
config>system>time>ntp# broadcastclient interface int11
config>system>time>ntp# no shutdown
The following example shows NTP enabled with the broadcastclient parameter enabled.
A:ALA-12>config>system>time# info
----------------------------------------------
ntp
broadcastclient interface int11
no shutdown
exit
dst-zone PT
start second sunday april 02:00
end first sunday october 02:00
offset 0
exit
zone UTC
----------------------------------------------
A:ALA-12>config>system>time#

Alcatel-Lucent 7750 SR OS Basic Specifications

General

Brand	Alcatel-Lucent
Model	7750 SR OS Basic
Category	Network Router
Language	English