CLI Usage
7750 SR OS Basic System Configuration Guide Page 21
Navigating in the CLI
The following sections describe additional navigational and syntax information.
• CLI Contexts on page 21
• Basic CLI Commands on page 23
• CLI Environment Commands on page 26
• CLI Monitor Commands on page 27
• Entering Numerical Ranges on page 46
CLI Contexts
Use the CLI to access, configure, and manage Alcatel-Lucent’s SR-Series routers. CLI commands
are entered at the command line prompt. Access to specific CLI commands is controlled by the
permissions set by your system administrator. Entering a CLI command makes navigation possible
from one command context (or level) to another.
When you initially enter a CLI session, you are in the ROOT context. Navigate to another level by
entering the name of successively lower contexts. For example, enter either the configure or show
commands at the ROOT context to navigate to the config or show context, respectively. For
example, at the command prompt, enter config. The active context displays in the command
prompt.
A:ALA-12# config
A:ALA-12>config#
In a given CLI context, you can enter commands at that context level by simply entering the text. It
is also possible to include a command in a lower context as long as the command is formatted in
the proper command and parameter syntax.
The following example shows two methods to navigate to a service SDP ingress level:
Method 1:
A:ALA-12# configure service epipe 6 spoke-sdp 2:6 ingress
*A:ALA-12>config>service>epipe>spoke-sdp>ingress#
Method 2:
A:ALA-12>config# service
A:ALA-12>config>service# epipe 6
*A:ALA-12>config>service>epipe# spoke-sdp 2:6
*A:ALA-12>config>service>epipe>spoke-sdp# ingress
*A:ALA-12>config>service>epipe>spoke-sdp>ingress#
To Next Page
Loading...
Need help?
General
