System Management
7750 SR OS Basic System Configuration Guide Page 327
lsr-load-balancing
Syntax lsr-load-balancing {lbl-only | lbl-ip | ip-only}
no lsr-load-balancing
Context config>system
Description This command configures system-wide LSR load balancing.
Hashing can be enabled on IP header at an LSR for spraying labeled IP packets over multiple equal
cost paths in ECMP in an LDP LSP and/or over multiple links of a LAG group in all types of LSPs.
In previous releases, the LSR hash routine operated on the label stack only. However, this lacked the
granularity to provide hashing on the IP header if a packet is IPv4. An LSR will consider a packet to
be IPv4 if the first nibble following the bottom of the label stack is 4. This feature is supported for
IPv4 support only and on IOM-3 and IMMs only. IPv6 packets are hashed on label stack only. The
hash on label and IPv4 header can be enabled or disabled at the system level only
Default disabled
lacp-system-priority
Syntax lacp-system-priority lacp-system-priority
no lacp-system-priority
Context config>system
Description This command configures the Link Aggregation Control Protocol (LACP) system priority on
aggregated Ethernet interfaces. LACP allows the operator to aggregate multiple physical interfaces to
form one logical interface.
Default 32768
Parameters lacp-system-priority — Specifies the LACP system priority.
Values 1 — 65535
location
Syntax location location
no location
Context config>system
Description This command creates a text string that identifies the system location for the device.
Only one location can be configured. If multiple locations are configured, the last one entered
overwrites the previous entry.
The no form of the command reverts to the default value.
Default none — No system location is configured.
To Next Page
Need help?
General
