System Management
7750 SR OS Basic System Configuration Guide Page 381
If the card firmware is upgraded automatically, a chassis cardUpgraded (event 2032) log event is
generated. The corresponding SNMP trap for this log event is tmnxEqCardFirmwareUpgraded.
During any firmware upgrade, automatic or manual, it is imperative that during the upgrade
procedure:
• Power must NOT be switched off or interrupted.
• The system must NOT be reset.
• No cards are inserted or removed.
Any of the above conditions may render cards inoperable requiring a return of the card for
resolution.
The time required to upgrade the firmware on the cards in the chassis depends on the number of
cards to be upgraded. On system reboot, the firmware upgrades can take from approximately 3
minutes for a minimally loaded 7750 SR-Series to 8 minutes for a fully loaded 7750 SR-12
chassis after which the configuration file will be loaded. The progress of the firmware upgrades
can be monitored at the console. Inserting a single card requiring a firmware upgrade in a
running system generally takes less than 2 minutes before the card becomes operationally up.
now — Forces a reboot of the router immediately without an interactive confirmation.
save
Syntax save [file-url] [detail] [index]
Context admin
Description This command saves the running configuration to a configuration file. For example:
A:ALA-1>admin# save ftp://test:test@192.168.x.xx/./100.cfg
Saving configuration .........Completed.
By default, the running configuration is saved to the primary configuration file.
Parameters file-url — The file URL location to save the configuration file.
Default The primary configuration file location.
Values file url: local-url | remote-url: 255 chars max
local-url: [cflash-id/][file-path], 200 chars max, including the cflash-id
directory length, 99 chars max each
remote-url: [{ftp://} login:pswd@remote-locn/][file-path]
remote-locn [ hostname | ipv4-address | [ipv6- address] ]
ipv4-address a.b.c.d
ipv6-address - x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x - [0..FFFF]H
d - [0..255]D
interface - 32 chars max, for link local addresses
255 chars max, directory length 99 chars max each
cflash-id: cf1:, cf1-A:,cf1-B:,cf2:,cf2-A:,cf2-B:,cf3:,cf3-A:,cf3-B:
To Next Page
Loading...
Need help?
General
