ALLEN & HEATH CQ-18T User Manual

 100
User Guide V1.1.0 Issue 1
Below the FX model controls are the FX Unit controls which are independent of the
FX model being used.
FX Unit Mode – ‘Shared’ allows multiple channels to send signal to the FX Unit
simultaneously, and for the output of the FX Unit to be sent to Main LR, Outputs or
other FX Units at different levels using either the PROCESSING / SENDS screen, or
the FADER screen. Shared mode is generally used for reverbs and delays.
‘Inserted’ allows the FX Unit to be used in a single input or output channel, to use a
Chorus on a violin for example.
FX Send Level – Adjust the overall level of signal coming into the FX Unit. This is
the same control as the fader on the right-hand side of the FADER screen when
this FX Unit is selected from ‘Sends to’.
FX Level to LR – Adjust the send level of the FX to the Main LR.
Mute Mode – Set Trails On to hear any reverb or delay trail fade out naturally when
muting an FX unit. Set Trails Off to have the FX mute instantly.
MUTE – Mute or unmute the selected FX Unit.

ALLEN & HEATH CQ-18T Specifications

General

Frequency range	20 - 20000 Hz
Channels quantity	18 channels
Supported sample rates	96 kHz
Digital sound processing	- bit
Phantom power	48 V
AC input voltage	100 - 240 V
AC input frequency	50/60 Hz
Power consumption (typical)	35 W
Output impedance	75 Ω
Built-in display	Yes
Compatible memory cards	SD, SDHC
Master (XLR) out	2
Number of microphone inputs	18
Video capability	-
USB connector type	USB Type-A, USB Type-B

Weight and Dimensions

Depth	242 mm
Width	346 mm
Height	89 mm
Weight	3000 g
Package depth	310 mm
Package width	430 mm
Package height	200 mm
Package weight	3800 g