1756-6.5.3 - December 1999
Logix5550 Controller to PLC-5C: Scheduled Communications 6-9
6. Enter an appropriate name for the network (e.g.,
“Sched_Logix5550_to_PLC5”) and click on Save.
Your ControlNet network should appear similar to that shown below:
7. Verify that the devices shown and the network node addresses displayed
are correct.
Verify the Network Properties
Make sure that the network update time (NUT), Max Scheduled Address,
and Max Unscheduled Address are set correctly.
1. Select Network from the main menu bar and Properties from the
pull-down menu:
To Next Page
Loading...
Need help?
General
