Atag i Series Technical Guide

Parameter chapter
When the boiler is installed, it is in principle ready to be put into service. Most settings of the control system are already
programmed from factory.
To change this setting, proceed as follows:
RESET
BACK OK
19°25/07/18 09:00
80°60°
ECO AUTO
Press OK to enter Menu
1.5 bar
Technical area
Language, date and time
Complete Menu
Configuration Wizard
Service
Faults
Menu
0
1
2
3
4
Network
<Not Available>
Boiler Parameters
<Not Available>
Zone 1 Parameters
From the controller Home screen,
press the BACK and OK buttons
at the same time for 7 seconds
1
Insert Code
007
Save
Insert technical code
Turn the selector wheel to highlight 007
as the Technical Code. Press OK to Save.
2
The screen below appears.
This way you have access to the complete
parameter level.
4
The screen below then appears.
Turn the selector wheel to highlight
Complete Menu. Press OK. It takes
a while to load the menu.
3
26

Atag i Series Specifications

General

Brand	Atag
Model	i Series
Category	Boiler
Language	English